this post was submitted on 02 Jun 2024
67 points (97.2% liked)
Linux
48323 readers
919 users here now
From Wikipedia, the free encyclopedia
Linux is a family of open source Unix-like operating systems based on the Linux kernel, an operating system kernel first released on September 17, 1991 by Linus Torvalds. Linux is typically packaged in a Linux distribution (or distro for short).
Distributions include the Linux kernel and supporting system software and libraries, many of which are provided by the GNU Project. Many Linux distributions use the word "Linux" in their name, but the Free Software Foundation uses the name GNU/Linux to emphasize the importance of GNU software, causing some controversy.
Rules
- Posts must be relevant to operating systems running the Linux kernel. GNU/Linux or otherwise.
- No misinformation
- No NSFW content
- No hate speech, bigotry, etc
Related Communities
Community icon by Alpár-Etele Méder, licensed under CC BY 3.0
founded 5 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
HDDs last best when not moved, as they dont lose the data that much when you dont use them. But they turn around, 24/7. It is insane. They use lots of electricity, produce heat, noise, and wear out without you doing anything.
SSDs have little tear from just being connected to a machine, they just dont do much. To my knowledge they also last longer a lot of times. But they are not as good for permanent storage and should be connected to power every half year or so.
I would always go with normal SATA SSDs, cheap, cool, just work.
NVMEs are so damn hot, small, expensive, often I dont see the reason.
You should look at power settings. HDDs can power down when not being read from or written to. It extends the time you wait when you need the data on them but can save on their lifetime / electric / heat.
I wouldn't be so sure about the lifetime - spinning up and spinning down put far more stress on the drive components than simply spinning at a constant rate.
Depends on how frequently you're accessing the data. If it's infrequently used, then spin up/down can be beneficial. But yes, you raise a good point. Thank you. :)