Linux

48624 readers

1332 users here now

From Wikipedia, the free encyclopedia

Linux is a family of open source Unix-like operating systems based on the Linux kernel, an operating system kernel first released on September 17, 1991 by Linus Torvalds. Linux is typically packaged in a Linux distribution (or distro for short).

Distributions include the Linux kernel and supporting system software and libraries, many of which are provided by the GNU Project. Many Linux distributions use the word "Linux" in their name, but the Free Software Foundation uses the name GNU/Linux to emphasize the importance of GNU software, causing some controversy.

Rules

Posts must be relevant to operating systems running the Linux kernel. GNU/Linux or otherwise.
No misinformation
No NSFW content
No hate speech, bigotry, etc

Related Communities

Community icon by Alpár-Etele Méder, licensed under CC BY 3.0

founded 5 years ago

MODERATORS

AgreeableLandscape@lemmy.ml

nooter692@lemmy.ml

MarcellusDrum@lemmy.ml

cypherpunks@lemmy.ml

cyclohexane@lemmy.ml

d3Xt3r@lemmy.nz

GRUB is confusing (lemmy.ca)

submitted 1 day ago by kionite231@lemmy.ca to c/linux@lemmy.ml

21 comments fedilink hide all child comments

hello,

I don't know if this is the right place to ask this question but could someone explain me how a UEFI system boots, I couldn't find a guide online. I want to know because I don't understand certain GRUB commands and how it get installed.

I just copy paste commands from Arch wiki and it just magically works without me knowing anything about it.

all the different distros use different grub command parameter and it's so confusing. eg, Arch and Gentoo.

Arch command: grub-install --target=x86_64-efi --efi-directory=esp --bootloader-id=GRUB Gentoo command: grub-install --efi-directory=/efi

why both command is different? exactly where does grub gets installed?

sorry if this is a naive question but i really don't understnad GRUB.

you are viewing a single comment's thread
view the rest of the comments

[–] AnnaFrankfurter@lemmy.ml 7 points 17 hours ago* (last edited 17 hours ago) (1 children)

What's confusing, when x86 initializes it preloads specific address in IP motherboard manufacturer has BIOS there that sets up first 512 bytes. and IP jumps to the new address then it sets up rest of /boot and switches your CPU to real mode up until that point it was in 8bit mode now it is in 16 bit. then jumps to that, now it switches to protected mode I.e. 32bit and loads kernel and initramfs (to solve chicken and egg problem) and then your os boots.

Throw in cryptsetup and shim and switching to 64 bit somewhere there.

[–] JustVik@lemmy.ml 2 points 12 hours ago* (last edited 12 hours ago)

Yes, x86 legacy is really confusing. Especially if you are going to write your own kernel or bootloader.