this post was submitted on 15 Jan 2024
125 points (97.0% liked)
Linux
48328 readers
659 users here now
From Wikipedia, the free encyclopedia
Linux is a family of open source Unix-like operating systems based on the Linux kernel, an operating system kernel first released on September 17, 1991 by Linus Torvalds. Linux is typically packaged in a Linux distribution (or distro for short).
Distributions include the Linux kernel and supporting system software and libraries, many of which are provided by the GNU Project. Many Linux distributions use the word "Linux" in their name, but the Free Software Foundation uses the name GNU/Linux to emphasize the importance of GNU software, causing some controversy.
Rules
- Posts must be relevant to operating systems running the Linux kernel. GNU/Linux or otherwise.
- No misinformation
- No NSFW content
- No hate speech, bigotry, etc
Related Communities
Community icon by Alpár-Etele Méder, licensed under CC BY 3.0
founded 5 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
FreeCAD requires a lot more clicks. Simple example: You want to extrude part of a sketch. In Fusion360 you select the part, hit extrude, done. In FreeCAD you can't extrude a part of a sketch, only whole sketches, so you have to make a new sketch, important the geometry of your previous sketch, repaint over the imported geometry to make it an actually sketch and now you are allowed to extrude it. When you have an extrusion that would result in multiple bodies, you have to redo this produce for each and every body, since FreeCAD extrusions are only allowed to produce one body. This can easily turn a 5sec operation into a 10min operation.
On top of that you have the topological naming problem that forces you do basically remoddel your whole thing from scratch if you want to change anything in the early build steps.
There are numerous ways to ease the pain (MasterSketch, Datum planes, ShapeBinder), but they all require a lot of discipline and planing ahead. You can't just YOLO your models in FreeCAD the way you can in Fusion360.
On the plus side, the discipline FreeCAD forces on you can result in cleaner results. In Fusion360 it's quite easy to model yourself in a corner were everything is underconstrained and will just exploded if you touch anything. Fusion360 will let you get away with a lot until it is to late. FreeCAD will go "I can't do that, Dave" a lot sooner and force you to clean up.
All that complaining aside, FreeCAD is my CAD tool of choice. I am never going to touch Fusion360 with its ever more restrictive licensing scheme ever again.