this post was submitted on 02 Feb 2024
101 points (89.8% liked)
Linux
48310 readers
645 users here now
From Wikipedia, the free encyclopedia
Linux is a family of open source Unix-like operating systems based on the Linux kernel, an operating system kernel first released on September 17, 1991 by Linus Torvalds. Linux is typically packaged in a Linux distribution (or distro for short).
Distributions include the Linux kernel and supporting system software and libraries, many of which are provided by the GNU Project. Many Linux distributions use the word "Linux" in their name, but the Free Software Foundation uses the name GNU/Linux to emphasize the importance of GNU software, causing some controversy.
Rules
- Posts must be relevant to operating systems running the Linux kernel. GNU/Linux or otherwise.
- No misinformation
- No NSFW content
- No hate speech, bigotry, etc
Related Communities
Community icon by Alpár-Etele Méder, licensed under CC BY 3.0
founded 5 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
I had a similar problem which was resolved by disabling the motherboard integrated graphics in bios settings.
Thank you ! It didn't seem to work on it's own, but I also noticed I wasn't booting in EFI mode, so maybe if I just change my booting partition and combine it with your advice it'll work...
Mine went back to no display only on boot, so I guess it didnt work for me either :( good luck tho!!
Aw, too bad :( Good luck to you as well, tho! I've bookmarked your comment, so I'll be back to tell you if I find the solution, however long it takes!
I still haven't found the solution, have you had any luck with yours?
I tried switching every UEFI setting that seemed to have something to do with booting or gpus, reinstalled gpu bios, upgrading mobo bios, getting a monitor I could plug without a switch... All to no avail.
Well, I think before upgrading the BIOS, one thing had a slightly different result: Setting the boot mode to UEFI and disabling CSM made it display "no gop (graphic output protocol)" after a few minutes, and it offered to either take me to the uefi settings or loading defaults (which implied going back to CSM), after which it boot this time go back to doing the same thing.
I don't think I've had this error since the mobo bios upgrade, but still no display unless I reboot, unless the computer had been turned in until recently. I'm kinda out of ideas...
…unfortunately no.. I work around it by knowing what buttons to press but it’s pretty stupid.