Linux

48328 readers

599 users here now

From Wikipedia, the free encyclopedia

Linux is a family of open source Unix-like operating systems based on the Linux kernel, an operating system kernel first released on September 17, 1991 by Linus Torvalds. Linux is typically packaged in a Linux distribution (or distro for short).

Distributions include the Linux kernel and supporting system software and libraries, many of which are provided by the GNU Project. Many Linux distributions use the word "Linux" in their name, but the Free Software Foundation uses the name GNU/Linux to emphasize the importance of GNU software, causing some controversy.

Rules

Posts must be relevant to operating systems running the Linux kernel. GNU/Linux or otherwise.
No misinformation
No NSFW content
No hate speech, bigotry, etc

Related Communities

Community icon by Alpár-Etele Méder, licensed under CC BY 3.0

founded 5 years ago

MODERATORS

AgreeableLandscape@lemmy.ml

nooter692@lemmy.ml

MarcellusDrum@lemmy.ml

cypherpunks@lemmy.ml

cyclohexane@lemmy.ml

d3Xt3r@lemmy.nz

Bridge WiFi between two devices? (lemmy.world)

submitted 8 months ago* (last edited 8 months ago) by LunchEnjoyer@lemmy.world to c/linux@lemmy.ml

20 comments fedilink hide all child comments

Not sure if that title is accurate, this field is not my strong point. Basically I'm about to move homes. And in my new (temporary) home I wont have access to ethernet, plus my server doesn't have a network card. I was therefore wondering if it was possible to bridge a connection between my laptop to my server with an ethernet cable. This would obviously be a short term solution, but I'm wondering if it's possible and if so, how? Or is it better to buy a cheap network card?

My laptop is running NixOS and my server Unraid, if it should be to any help.

you are viewing a single comment's thread
view the rest of the comments

[–] cyborganism@lemmy.ca 5 points 8 months ago (3 children)

Of course you can.

However, my networking knowledge is not super fresh. I believe you need a special ethernet cable for this. A crossover ethernet cable. Then you have to manually set the IP address on both ends for that interface to something kind 192.168.0.1 and 192.168.0.2 Here's a quick how-to that shows an example.

Or... You don't have an individual router? Couldn't you just plug it in the router by ethernet cable?

[–] redcalcium@lemmy.institute 12 points 8 months ago (1 children)

I believe a crossover cable is no longer needed these days as most ethernet adapters implements Auto-MDIX .

[–] cyborganism@lemmy.ca 3 points 8 months ago

Ah ok.

I was born in the 1900's so... You know, things have changed in the 21st century.

[–] axzxc1236@lemm.ee 6 points 8 months ago

If both Ethernet NIC is over 1gbps, you are fine with using normal cable.

[–] LunchEnjoyer@lemmy.world 1 points 8 months ago

Thanks I'll try this!