this post was submitted on 16 May 2024
96 points (74.2% liked)

Memes

45719 readers
1057 users here now

Rules:

  1. Be civil and nice.
  2. Try not to excessively repost, as a rule of thumb, wait at least 2 months to do it if you have to.

founded 5 years ago
MODERATORS
gary_host_laptop@lemmy.ml
sexy_peach@feddit.de
cyclohexane@lemmy.ml
cypherpunks@lemmy.ml
96
4 sosp'cks to 1 kitt (lemmy.world)
submitted 6 months ago by no_comment@lemmy.world to c/memes@lemmy.ml
11 comments fedilink hide all child comments
 
you are viewing a single comment's thread
view the rest of the comments
[–] SoylentBlake@lemm.ee 15 points 6 months ago (2 children)

You do you boo but Metrics fucking awesome. It's simple, conversions are super easy, etc. it's just basic numbers. You can thoughtlessly multiply or divide (assuming you could thoughtlessly do that before).

You want a real shite headache? Try translating tenths of inches. I'd just burn the blueprints and tell them to try again.

[–] eatham@aussie.zone 6 points 6 months ago

OP was being sarcastic.

[–] DesolateMood@lemm.ee 2 points 6 months ago (1 children)

Serious question about this argument. Try translating tenths of inches... to what? I assume you're not talking about converting to metric because then any unit is problematic, and if you're using tenths of an inch then you're using inches, not something else, so... what's the problem?

[–] SoylentBlake@lemm.ee 1 points 6 months ago

The most common place to find .1" is on micrometers. And that's just fine until you need to switch it back to imperial or metric for the next processing...which the rest of your tooling is in.

.1" is roughly 2.54mm

.1", fractionally is ~7/64

7/64 is roughly 2.77mm

See how this is recipe for disaster?