archer

joined 6 months ago
sorted by: new top controversial old
40
Are all FRU for a particular Lenovo Marketing part number compatible/identical? (lemmy.ml)
submitted 3 months ago* (last edited 3 months ago) by archer@lemmy.ml to c/selfhosted@lemmy.world
7 comments fedilink
 

I'm asking here since I assume a lot of you guys are running homelabs on Lenovo hardware.

I have two M720q Tiny that came with one 8 GB 2400MHz SoDIMM RAM each (see picture). I upgraded one to 2x 32 GB RAM and want to reuse the sticks in the other one for 16 GB in total and dual channel use. They have different FRU numbers (see picture) but I assume it's the same marketing part number and I guess my plan works?

Can anyone confirm? I'm just unsure about dual channel since it's not exactly the same RAM and I'm used to using exact pairs.

Thanks!

Steam: Controller not working anymore in Forza Horizon 4 in c/linux@lemmy.ml
[–] archer@lemmy.ml 2 points 3 months ago (1 children)

So... no idea what happened but it works again.

Just in case anyone stumbles upon this thread at some point here are my current settings:

  • The compatibility layer is proton-ge-custom (from AUR)
  • Steam Input Translation in the Forza Horizon 4 Controller Settings is enabled using the "Official Layout for Forza Horizon 4 - Gamepad"
  • Regular mode (not big picture mode)
  • Steam Overlay is enabled

I still have the issue that on some screens it shows the keyboard buttons and not the controller buttons but since the controller works anyway I don't really care (it's just the optics).

Thanks everyone for your suggestions! :)

Steam: Controller not working anymore in Forza Horizon 4 in c/linux@lemmy.ml
[–] archer@lemmy.ml 1 points 4 months ago

Normally regular mode, but I did try big picture with no luck. I also tried Steam overlay on and off. I will try again though all four possibiltues and read up on the GitHub issue thanks!

Steam: Controller not working anymore in Forza Horizon 4 in c/linux@lemmy.ml
[–] archer@lemmy.ml 1 points 4 months ago (1 children)

Any fix?

Steam: Controller not working anymore in Forza Horizon 4 in c/linux@lemmy.ml
[–] archer@lemmy.ml 2 points 4 months ago

I only have this one game that I need a controller for

42
Steam: Controller not working anymore in Forza Horizon 4 (lemmy.ml)
 

So I've been playing Forza Horizon 4 for a while without any issues using a XBox One Controller via Bluetooth. First i used Proton experimental and later Proton GE. Absolutely no problem.

Now however, the controller is not being recognized in game anymore (the on screen buttons show keyboard keys, not gamepad buttons) and I can't use any of the buttons (except the screenshot one). In the Steam menu, the controller test settings, big picture mode etc. it works fine and its recognized normally.

I didn't make any changes (before it happened, now of course it tried a bunch of stuff) but I did upgrade the system normally.

Any ideas what might have caused this issue?

Question on moving hard drives in c/linux@lemmy.ml
[–] archer@lemmy.ml 4 points 4 months ago (2 children)

So install back both disks, make a bootable gparted stick and do the cloning from there? The new disk is basically empty save the new file system, but ofc I can just delete that.

Question on moving hard drives in c/linux@lemmy.ml
[–] archer@lemmy.ml 1 points 4 months ago (1 children)

I think it's best to start from scratch since I didn't lose any data (yet). How would you tackle this move?

Question on moving hard drives in c/linux@lemmy.ml
[–] archer@lemmy.ml 1 points 4 months ago

Maybe I should start over since I still have the old disk. What would be the best/proper way to swap an older smaller disk for a new larger one?

Question on moving hard drives in c/linux@lemmy.ml
[–] archer@lemmy.ml 2 points 4 months ago (1 children)

No UUIDs, only paths. When booting from a live system I noticed /etc/fstab is empty. Also, there where a bunch of partitions on /dev/sda and I can't see any on /dev/nvme0n1

No not consciously

51
Question on moving hard drives (lemmy.ml)
submitted 4 months ago* (last edited 4 months ago) by archer@lemmy.ml to c/linux@lemmy.ml
10 comments fedilink
 

I'm running Proxmox on a Lenovo ThinkCentre and I decided to swap the internal 256 GB 2,5" SSD for a 500 GB NVME.

I installed the new NVME alongside the old SSD, and formated it in ext4 with a single partition. I then proceeded to 'dd /dev/sda /dev/nvme0n1' and it went through without an error.

My impression was that it would clone all content from the old drive to the new, but it wouldn't boot the new drive. I then logged in and set a boot flag via fstab a, but that only helped me boot but the system gets stuck at "waiting for root file system".

Nothing is lost as the old drive still works fine when installed but how do I complete the swap correctly so I can go NVME-only?

Thank you!

My Windows Computer Just Doesn't Feel Like Mine Anymore in c/technology@lemmy.world
[–] archer@lemmy.ml 26 points 4 months ago (2 children)

Ask your doctor if Linux is right for you

YouTube videos are skipping to the end for users with adblockers in c/technology@lemmy.world
[–] archer@lemmy.ml 2 points 5 months ago (1 children)

Does anyone know an alternative YT app for BOTH Android phones and Android TV that allows for synched playlists?

Replace Torrenting with Usenet in c/piracy@lemmy.dbzer0.com
[–] archer@lemmy.ml 3 points 6 months ago (1 children)

You can use those on usenet, too. Just add your new trackers and download client, the rest of the -arr stack can remain as is.

Kagi silently removed all references to Google's index from their website in c/technology@lemmy.world
38
[solved] Using Nextcloud as a directory/folder/remote location (lemmy.ml)
submitted 6 months ago* (last edited 6 months ago) by archer@lemmy.ml to c/selfhosted@lemmy.world
24 comments fedilink
 

Hi guys

Is there any way to access Nextcloud files (self hosted) in a file manager just like a regular directory or remote location? So the way iCloud or Dropbox allow you to access files and use them for example to upload them in a browser. So far I only managed to access the files in the Nextcloud WebUI or via the command line (but then a resync is necessary).

Any input is appreciated. Thanks!

view more: next ›